Use material：sus303
Subordinate industry：Hardware
Technological requirements：surface finish of 0.8, concentricity 0.02 round beating0.035, slender, and stainless steel parts. One-time setup complete car outside diameter milling on both sides of milling surrounded and cut off.
Processing equipment：RNC-V15E RNC-V20E can be processed
Technological requirements：the surface finish of 0.8, one-time setup to complete thedrilling cars outside diameter, cut off.
Processing equipment：RNC-V15E
Use material：S316
Subordinate industry：Cycling
Technological requirements：parts surface finish of 0.8 or stepped end face open rivet hookgroove outside diameter needs turning, milling flat bit side drilled a single setupcompleted.
Processing equipment：RNC-20E
Use material：Aluminum
Technological requirements：the surface finish of 0.8, a fixture complete car outside diameter, grooving, threading, milling surrounded and cut off.
Processing equipment：RNC-V20E
Technological requirements：the surface finish of 0.8 one-time setup complete caroutside diameter drilled side holes milling side cut off.
Use material：Copper
Technological requirements：concentricity 0.01 one-time setup complete vehicles outside diameter, cut surface finish of 0.8.
Technological requirements：completion of the one-time setup the car outside diameter, threading, cut off.
Technological requirements：surface finish of 0.8 one-time setup completed car outside diameter milling on both sides threading cut.
Technological requirements：1.6 surface finish this part of the thread requirementsone-time setup completed drilling car outside diameter threading cut.
Technological requirements：one-time setup completed drilling the car outside diameterdrill side holes milling side cut off.
