Use material：Aluminum

Subordinate industry：Auto Parts

Technological requirements： the surface finish of parts should reach 0.8, all size accuracy of less than 0.02, need to be turning all external diameter, drilling, boring, side hole one time clamping completed.

Processing equipment：RPJYG205E

Use material：Aluminum

Subordinate industry：Automotive

Technological requirements：surface finish of 1.6, one-time setup completed drillingmonitoring and control, milling on both sides of the car outside diameter, grooving,cutting.

Processing equipment：RNC-V20E

Use material：SUS430

Subordinate industry： the automotive industry (Dongfeng Automobile)

Technological requirements：the required surface finish of 0.8 over dimensional tolerancesfor the accuracy of the M-Class more needs turning ∮ 0.7 OD, grooving, cut a fixturecomplete.

Processing equipment：RNC-15E RNC-20E can be processed

Use material：SUS430

Subordinate industry：industry

Technological requirements：surface finish of 0.8 the outer teeth without burr, smooth inner bore, linear dimension tolerances up to more than the M-Class, the required theturning outer diameter, turning threaded processing within the hole, and arc parts,cut a fixture complete.

Processing equipment：RNC-15E RNC-20E can be processed

Use material：material A6061-T6

Subordinate industry：the automotive industry (Dongfeng Automobile)

Technological requirements：part surface finish required more than 0.8 the side 1.2mmcircular groove tolerance of ± 0.02 the required processing within the hole theouter diameter side 1.2mm slot external thread cut a fixture complete.

Processing equipment：RNC-20E

Use material：sus303

Subordinate industry：Automotive

Technological requirements：the surface finish of 0.8, the workpiece difficult tocircular hole in the processing side. Completion of the one-time setup threading caroutside diameter, the side of the car round bore, milling surrounded and cut off.

Processing equipment：RNC-V15E RNC-V20E can be processed

Use material：45 #

Subordinate industry：Automotive

Technological requirements：the surface finish of 0.8, one-time setup to complete thedrilling the car outside diameter, threading, cut.

Processing equipment：RNC-V15E

Use material： Copper

Subordinate industry：Automotive

Technological requirements：surface finish of 0.8, a fixture complete vehicles outside diameter, grooving, milling on both sides, threading, cut off.

Processing equipment：RNC-V15E RNC-V20E can be processed

Use material：sus303

Subordinate industry：Automotive

Technological requirements： surface finish of 0.8, one-time setup completed car outside diameter milling on both sides, grooving, cut.

Processing equipment：RNC-V20E

Use material：H62

Subordinate industry：Automotive industry

Technological requirements：internal and external finish of 0.8, the highest dimensional accuracy of 0.02, need turning end circular groove, internal oblique hole and all the outer diameter, cut a fixture completed.

Processing equipment：RNC-20E